Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 1. Cisco Catalyst and E Series Data Sheet. Cisco Catalyst , Catalyst E, Catalyst and Catalyst E Switch with Catalyst Series VPN Services Port Adapter. buy & sell Cisco Catalyst switch , best price and OFF for New & Used & Refurbished Cisco and E-Series Switches.
|Published (Last):||12 July 2016|
|PDF File Size:||17.44 Mb|
|ePub File Size:||11.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
To print the manual completely, please, download it.
Cisco Switch Catalyst 6500
Page 23 of Please improve this by adding secondary or tertiary sources. Layer 3 operations, the switch must be run in hybrid mode.
Catalyst series chassis and module power and heat values 16 pages. These line cards have 2x8gb connections to the switch fabric and no classic bus connection. However, if any part of this operation is skipped, errors will occur resulting in a stalled bus and ultimately a chassis reload.
Page 20 of Because of this, power supplies are a key element of configuration. The PFC makes forwarding decisions in hardware.
Used Cisco Catalyst Series Switches, , E, E, E, E
This was first introduced into the Supervisor Engine The supervisor then looks up the correct egress port, access lists, policing and any relevant rewrite information on the PFC. Throughout the Cisco Catalyst Series, modules are: This article relies too much on references to primary sources. This is placed on the result bus rBus and sent to all line cards. Please help improve it or discuss these issues on the talk page. Page 3 of The MSFC runs all software processes, such as routing protocols.
Page 22 of Ideal for enterprises and service providers seeking to reduce their total cost of ownership, the. Page 21 of This eliminates the need for any connection to the classic bus or requirement to use the shared resource of the supervisor. Learn how and when to remove these template messages.
This method of forwarding was first introduced with the Supervisor 2 engine. The ctalyst chassis can support up to a maximum of W 90A 42V of power, because of backplane limitations.
The catslyst is derived from a chassis using 2x8gb ports on 8 slots of a chassis: In this mode, assuming all line cards have a switch fabric connection, an ingress packet is queued as before and its headers are sent along the dBus to the supervisor. This mode is the default shipping mode for Cisco products and enjoys support of all new features and line cards. Please help improve the article with a good introductory style.
Upon insertion, the longest of these makes first contact and stalls the bus to avoid corruption. The speed of the classic bus is 32gb half duplex since it is a shared 66509 and is the only supported way of connecting a Supervisor 32 engine or Supervisor 1 to a Page 8 of As Cisco’s premier intelligent multilayer.
Cisco Catalyst Series Switches Price & Datasheet
The number is doubled to the switch fabric being ‘full duplex’. The number is doubled because of the switch fabric being ‘full duplex’. Don’t show me this message again. The initial egress line card takes this information and forwards datsaheet data to the correct line card along the switch fabric.
Cisco Catalyst 6513 WS-C6513-E Data Sheet
With the introduction of catalgst E and E series chassis, the maximum power supported has been increased to in excess of W A 42V. This is also the default and recommended way to configure power supplies.
This page was last vatasheet on 12 Februaryat The latest generation supervisor is the Supervisor 2T. December Learn how and when to remove this template message. This article provides insufficient context for those unfamiliar with the subject.