GOCYCLE MANUAL PDF


Gocycle GS – Owner’s Manual (EN) – English. Tom. 4 months ago; Updated. Follow. Download the latest Gocycle GS Owner’s Manual. Gocycle GS Owners. Technical Bulletins, Owner’s Manuals and Documentation. GreenMiles is your Official Gocycle Partner for the Benelux. To meet the growing demand for mobility in and between urban areas, GreenMiles is convinced that.

Author: Docage Tazuru
Country: Italy
Language: English (Spanish)
Genre: Politics
Published (Last): 12 May 2014
Pages: 414
PDF File Size: 9.19 Mb
ePub File Size: 1.33 Mb
ISBN: 763-7-15954-265-4
Downloads: 7648
Price: Free* [*Free Regsitration Required]
Uploader: Arashir

Nevertheless, you must inspect the Gocycle every miles to see if any of the components have cracks and need replacing. Read carefully to ensure the proper and safe operation and storage of the battery. Failure to inspect the hub gear bearing adjustment may have serious consequences and could result in serious bodily injury or even death. Extreme caution should be used when attempting to touch any part of the motor after it has been in operation—the same caution you would use in the kitchen with hot pots or pans or Delivery State allows 60 miles km of normal usage before the motor will cease to operate.

The following important information applies to your Gicycle lithium battery.

Gocycle User Manual & FAQ

When the Gocycle stops and after a short amount of time of inactivity, the DRL will turn off. From time to time, it might be necessary to adjust your shifting; for example, if you hear a noise from your rear hub or amnual Gocycle is not holding in gear.

  MAKALAH BRONKIEKTASIS PDF

By choosing to ride a Gocycle, you assume the responsibility for these risks, and it is important that you know how to ride responsibly and to exercise proper maintenance to minimise such risks and potential damage. In addition to riding modes 1 through 4, your Gocycle comes pre-programmed with a number of helpful modes to assist with gear shift adjustment and fault-finding.

Maximum Design Limit Front and Rear Reflectors Stopping the Gocycle The Gocycle is equipped with front and rear hydraulic disk brakes, operated by two levers on the handlebars shown.

Page 49 The following sections explain the differences between the riding modes and how to select them. Such risks are increased in busy, urban environments with moving traffic. Exercise caution to avoid brake fluid coming into contact with painted surfaces. Do I need to remove the battery from the frame for charging.

Lift the front wheel so that is it off the ground.

Gocycle User Manual & FAQ – Service & Repair Manuals

Diagnosis Modes Your Gocycle is pre-programmed with focycle number of modes to assist in fault diagnosis, should an issue occur. Warranty Warranty Registration For your continued satisfaction and safety whilst riding your Gocycle, we strongly encourage you to register your Gocycle with us. Rotate so that one of the holes in the clock nut Look carefully at all the components under good lighting. Daytime Running Light drl 6.

  CLAUDIO BERTONI NI YO PDF

The charge value corresponds to W equal to burning a light bulb 2. Gocyfle can operate your Gocycle in different modes to suit your personal riding style. DOT 4 brake fluids will strip paint. If you find any of the following items to be damaged or incorrectly adjusted then please seek immediate assistance from your manyal Authorised Gocycle Service Centre who will help rectify any issue. Page 51 Refer to the table in 6.

Where is the battery located? When movement of the rear wheel is detected, one LED will light on the right-hand side of the dashboard display. This indicator is available on the built-in bicycle display.

Tool Holder installation is complete. What is the battery life? Unless you register your Gocycle, after 60 miles kmyour Gocycle motor will cease to operate.

GOCYCLE G3 OWNER’S MANUAL Pdf Download.

No LEDs visible Resolution: The braking performance of new brake pads will increase over time. Orientate the Tool Holder as shown 1. Lower position aligned Ensure the bolt hole and stem upper position or lower position hole are fully aligned. Refer to the table in 6. Rotate the rear wheel.