How to Set the Temperature on a HAKKO FXD. 1. Turn ON the power. The display will show the following: 2. Let the temperature come up to the factory. View and Download Hakko Electronics FXD instruction manual online. FX- D Soldering Gun pdf manual download. When you use the HAKKO FX for the first time, note that calibration is required (Refer to the HAKKO FXD instruction manual.).
|Published (Last):||6 May 2012|
|PDF File Size:||4.70 Mb|
|ePub File Size:||18.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
Then bend the iron cord at various locations along its length, including in the strain relief area.
Please check to make sure that all items listed. When making repairs or replacing. Heater control will begin after the new set temperature is displayed. Got it, continue to print.
Since the soldering iron can reach a very high temperature, please work carefully. High-output, temperature controlled soldering station 23 pages. Don’t show me this message again.
Comments to this Manuals Your Name. The display will return to if you press the button hakkko selecting. Except the case especially indicated, always turn the power switch OFF and disconnect the power plug before performing any maintenance procedure. Turn the power off when the FXD is not in use for an extended period.
HAKKO | Soldering iron | HAKKO FXD
By pressing ‘print’ button fz-888d will print only current page. Page 4 Heater control will begin after the new set temperature is displayed. Please note that some languages may not be available depending on the product. Press the button to change the display to 2. Be sure to ground the unit during use. Either will be displayed if you press the button when is displayed. Custom” is selected in the password setting. Don’t have an account?
Turn the power on while pressing the button. The plastic parts are not insulators, they are conductors.
Use Adjustment Mode to perform the temperature adjustment. Add to my manuals Add.
Hakko Electronics FX-888D Instruction Manual
Efficient soldering depends upon the temperature, quality and quantity of the solder and flux. Keep this manual readily accessible for reference. Manyal you press the button, the display will move to the password setting mode selection screen. The factory default is “0: Part Name Specifications Item No. Be sure to observe. ENTER will be switched alternately if you mwnual the button. After use Always clean the tip and coat it with fresh solder after use.
Page of 16 Go.
Apply the following service procedure as dictated by the conditions of usage. To print the manual completely, please, download it.
There are three choices for the password setting. Enter text from picture: High-output temperature controlled soldering station 23 pages. This product includes such features as electrically conductive plastic parts and grounding of the unit.